Installation Instructions

FormNo.3445-808RevA

RearAttachmentReceiver

Workman

GTXSeriesUtilityVehiclewithSteelCargoBed

ModelNo.07186

InstallationInstructions

Note:Determinetheleftandrightsidesofthemachinefromthenormaloperatingposition.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

ProcedureDescription

Qty.

Use

Nopartsrequired

–

Preparethemachineforinstallation.

Rearattachmentreceiver1

Jamnut1

Button-headbolt1

T-handle1

Locknut(3/8inch)

Carriagebolt(3/8x1inch)

Installthekit.

PreparingtheMachine

NoPartsRequired

Procedure

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Shutofftheengineandremovethekey.

g038447

Figure1

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3445-808*

PAGE 1
Form No. 3445-808 Rev A Rear Attachment Receiver Workman® GTX Series Utility Vehicle with Steel Cargo Bed Model No. 07186 Installation Instructions Note: Determine the left and right sides of the machine from the normal operating position. Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Prepare the machine for installation.
PAGE 2
Installing the Kit Parts needed for this procedure: 1 Rear attachment receiver 1 Jam nut 1 Button-head bolt 1 T-handle 4 Locknut (3/8 inch) 4 Carriage bolt (3/8 x 1 inch) Procedure 1. Secure the T-handle to the rear attachment receiver using the jam nut and button-head bolt (Figure 2). g355574 Figure 2 1. T-handle 2. Jam nut 3.
PAGE 3
2. Secure the rear attachment receiver to the bed using 4 carriage bolts (3/8 x 1 inch) and 4 locknuts (3/8 inch) as shown in Figure 3. 3. Torque the 4 locknuts (3/8 inch) to 28 N∙m (21 ft-lb). g355573 Figure 3 1. Locknut (3/8 inch) 2.
PAGE 4