Installation Instructions

FormNo.3407-174RevB

WindshieldKit

Workman

GTXUtilityVehiclewithCanopy

ModelNo.07151

InstallationInstructions

Installation

PreparingtheMachine

NoPartsRequired

Procedure

1.Movethemachinetoalevelsurface(boxAofFigure1).

2.Engagetheparkingbrake(boxBofFigure1).

3.Shutofftheengine(boxCofFigure1).

4.Removethekeyfromtheignition(boxDofFigure1).

g035453

Figure1

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3407-174*B

PAGE 1
Form No. 3407-174 Rev B Windshield Kit Workman® GTX Utility Vehicle with Canopy Model No. 07151 Installation Instructions Installation 1 Preparing the Machine No Parts Required Procedure 1. Move the machine to a level surface (box A of Figure 1). 2. Engage the parking brake (box B of Figure 1). 3. Shut off the engine (box C of Figure 1). 4. Remove the key from the ignition (box D of Figure 1).
PAGE 2
. 2 For installation on machines equipped with Model 07921 or 07922 canopies only: In the hole above the windshield support, install the windshield mounting brackets to the canopy tubes (Figure 3).
PAGE 3
4. Secure the top windshield to the canopy tubes using the 2 receiver clips (Figure 5). g037382 Figure 5 1. Top windshield 5. 2. Receiver clip Secure the rest of the bottom windshield to the brackets on the canopy tubes using 3 shoulder screws (5/16 x 1-1/4 inches), 3 backup washers, 6 flange bushings, and 3 flange nuts (5/16 inch) as shown in Figure 4.
PAGE 4