Installation Instructions

FormNo.3403-942RevB

DoorKit

Workman

GTXUtilityVehiclewithCab

ModelNo.07150

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Parts

1x1x2x2x

8x4x2x2x2x

2x6x2x4x

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3403-942*B

PAGE 1
Form No. 3403-942 Rev B Door Kit Workman® GTX Utility Vehicle with Cab Model No. 07150 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Parts 1x 1x 8x 2x 4x 2x © 2016—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 2x 2x 6x Register at www.Toro.com.
PAGE 2
Preparing the Machine 1. Park the machine on a level surface. 2. Engage the parking brake. 3. Shut off the engine. 4. Remove the key from the ignition. Figure 1 Installing the Door Kit 1. Secure the door straps and springs to the doors as shown in Figure 2.
PAGE 3
2. Place a brass washer on each of the 4 hinge posts and then carefully drop the doors into place as shown in Figure 3.
PAGE 4
3. Secure the door straps and springs to the frame as shown in Figure 4.
PAGE 5
4. Install the door latches as shown in Figure 5. Note: If the doors do not latch properly, adjust the assembly or install the extra shims until they do.
PAGE 6
Notes:
PAGE 7
Notes:
PAGE 8