Operator's Manual

InspectingtheBrakes
ServiceInterval:Every100hours
Brakesareacriticalsafetycomponentofthemachine.
Aswithallsafetycomponents,theyshouldbeclosely
inspectedatregularintervalstoensureoptimum
performanceandsafety.Thefollowinginspections
shouldbedoneevery100hours:
•Inspectthebrakeliningforwearordamage.Ifthe
lining(brakepad)thicknessislessthan1.6mm
(1/16inch),youshouldreplacethebrakelining.
•Inspectthebackingplateandothercomponents
forsignsofexcessivewearordeformation.If
anydeformationisfound,replacetheappropriate
components.
•Checkthebrake-uidlevel;refertoCheckingthe
Brake-FluidLevel(page50).
ReplacingtheServiceand
Parking-BrakePads
ServiceInterval:Every400hours
ContactyourauthorizedAuthorizedToroService
Dealertoinspectandpossiblyreplacetheserviceand
parking-brakepads.
ChangingtheBrakeFluid
ServiceInterval:Every1,000hours
ContactyourauthorizedT orodistributor.
BeltMaintenance
ServicingtheDriveBelt
CheckingtheDriveBelt
ServiceInterval:Aftertherst8hours
Every200hours
1.Parkthemachineonalevelsurface.
2.Engagetheparkingbrake.
3.Shutofftheengineandremovethekey.
4.Raisethecargobedandsecureitwiththeprop
rod;refertoRaisingtheCargoBedtotheDump
Position(page18).
5.ShiftthetransmissionintoNEUTRAL.
6.Rotateandinspectthebelt(Figure66)forsigns
ofexcessivewearordamage.
Note:Replacethebeltifitisexcessivelyworn
ordamaged;refertoReplacingtheDriveBelt
(page52).
g034106
Figure66
1.Generator-pivotnut
5.Drivebelt
2.Generator-pivotbracket
6.Primaryclutch
3.Startergenerator7.Starter-generatorbelt
4.Secondaryclutch
7.Lowerthecargobed.
51