Installation Instructions

ManualsBrandsToro ManualsVehiclesHose Reel Mounting Kit, Workman GTX Series Utility Vehicle

FormNo.3406-359RevA

HoseReelMountingKit

Workman

GTXSeriesUtilityVehicle

ModelNo.07027

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Safety

SafetyandInstructionalDecals

Safetydecalsandinstructionsareeasilyvisibletotheoperatorandarelocatednearanyareaofpotential

danger.Replaceanydecalthatisdamagedorlost.

133-7202

1.Attention—readtheOperator’sManual;donotcarrymore

than45kg(100lb).

133-4641

1.Warning—donotcarryanypassengers.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3406-359*A

Summary of content (4 pages)

PAGE 1
Form No. 3406-359 Rev A Hose Reel Mounting Kit Workman® GTX Series Utility Vehicle Model No. 07027 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost.
PAGE 2
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Use Qty. 1 No parts required – Prepare the machine. 2 Hose-reel mount Tube mount Hex-head screw (1/2 x 2-1/4 inches) Locknut (1/2 inch) Clevis pin (1/2 x 2 inches) Hairpin cotter 1 1 1 1 1 1 Install the hose-reel mount. The hose-reel mount is designed to fit aftermarket hose reels with mounting patterns of either 40 x 23 cm (15-3/4 x 9 inches) or 39 x 25 cm (15-7/16 x 10 inches).
PAGE 3
2 Installing the Hose-Reel Mount Parts needed for this procedure: 1 Hose-reel mount 1 Tube mount 1 Hex-head screw (1/2 x 2-1/4 inches) 1 Locknut (1/2 inch) 1 Clevis pin (1/2 x 2 inches) 1 Hairpin cotter Figure 2 1. Tube mount 2. Front hitch attachment 3. ‘T’ handle 4. Clevis pin (1/2 x 2 inches) and hairpin cotter Installing the Hose-Reel Mount to the Front of the Machine 4.
PAGE 4
. Insert the tube mount into the front hitch attachment and secure it with the clevis pin (1/2 x 2 inches) and hairpin cotter (Figure 3). 5. Tighten the ‘T’ handle on the front hitch attachment (Figure 3). Installing the Hose-Reel Mount to the Rear of the Machine 1. Insert the tube mount into the hose-reel mount until the holes in the tube mount align with the front holes in the hose-reel mount (Figure 4). Figure 5 1. Tube mount 3. Clevis pin (1/2 x 2 inches) and hairpin cotter 2.