Form No. 3446-674 Rev A Light Kit Greensmaster® 3150/3250-D or TriFlex® Traction Unit Model No. 04554 Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. decal127-6126 127–6126 1. Headlights 3. Headlights and rear lights 2. Off © 2021—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Register at www.Toro.com.
Installation 1 Preparing the Machine No Parts Required Procedure 1. Park the machine on a level surface. 2. Engage the parking brake. 3. Shut off the engine and remove the key. 4. Disconnect the negative ( - ) battery cable from the battery. g027755 Figure 1 2 1. Nut (part of the light assembly) 5. Light assembly 2. Lock washer (part of the light assembly) 6. U-bolt 3. Bracket 4. Bolt (part of the light assembly) 7. Nuts 2. Install the light assembly as shown in Figure 1.
Installing the Wiring Harness Parts needed for this procedure: 1 Wiring harness 10 Cable ties (14.5 inch) 2 Cable ties (7.25 inch) 1 Wiring harness adapter (Greensmaster 3150 and 3250 models prior to 2015 only) 1 Splice, 12-10 awg (Greensmaster 3150 models prior to 2015 only) 2 Splice, 16-14 awg (Greensmaster 3150 and 3250 models prior to 2015 only) g027850 Figure 4 Greensmaster 3150 Procedure Ensure that the wiring harness is routed away from any hot, sharp, or moving parts. 1.
3. 4. Secure the wiring harness near the light assemblies with the 2 (7.25 inch) cable ties into the available hole on the light bracket (Figure 1). Plug the light kit wiring harness into the terminal on the main wiring harness. 1. Splice the black wire, that was previously leading to connector J6, to the black wire of the light kit adapter using splice connector 16-14 awg. 2.
. Connect the switch to the wiring harness. 6. Install the console shroud. 7. Connect the negative battery cable. Installing the Switch for the Greensmaster TriFlex 1. Remove the 7 hex bolts securing the console cover in place and remove the console cover. 2. From inside the console, press the plug out of the hole (Figure 10). g027762 Figure 8 1. Fuse 2. Fuse block 5. Install the console shroud. 6. Connect the negative battery cable.
Operation 5 Operating the Light Switch Installing the Rear-Light Kit (Optional) Note: To adjust the lights, you can loosen the mounting hardware, aim the lights as desired, and tighten the hardware to secure the lights in the newly adjusted position. Parts needed for this procedure: 1 The light switch has 3 positions; refer to Figure 12. Rear-light kit (optional) Procedure Install the rear-light kit assemblies as shown in Figure 11. decal127-6126 Figure 12 1. Headlights 2.
Notes:
