Operator's Manual

4
Note: As dethatcher blades wear, the diameter of the reel
will decrease and setting will change. Check adjustment
periodically to insure desired setting is achieved.
1
2
Figure 3
1. Grass shield 2. Grass shield screws
Note: Bar on rear of shield is adjustable to decrease ground
clearance. Make sure bar is repositioned if dethatcher
blades are replaced.
Adjusting Front Roller Scraper
1. Loosen locknut and jam nut securing each end of front
roller scraper to brackets.
2. Adjust roller scraper until there is .030”–.060”
clearance between scraper and roller.
1
2
Figure 4
1. Front roller scraper 2. Roller bracket
3. Tighten locknuts and jamnuts securing roller scraper to
brackets.
Adjusting Rear Wheel Scrapers
1. Loosen jam nut and locknut securing each rear wheel
scraper to bracket.
2. Adjust each scraper until there is .030” – .060”
clearance between front edge of scraper and wheel.
1
2
Figure 5
1. Rear wheel scraper 2. Jamnuts
3. Tighten locknuts and jamnuts securing scrapers to
brackets.
Note: Scraper adjustment can be changed to meet turf
conditions.
Installing Dethatcher Units
Important If dethatcher is set at a negative setting, care
must be taken to prevent damage to reel blades, due to
contact with concrete floors or a paved surfaces.
Note: When mounting Dethatcher Units on a Greensmaster
3200 or 3200–D traction unit, Pull Link Kit, Toro Part No.
94–9630 must be installed to each unit. Pull link kits are
not required when installing Dethatcher Units on any other
Greensmaster models.
1. Park the machine on a level surface, lower lift arms,
stop engine and set parking brake.
2. Slide dethatcher unit under traction unit pull frame
while hooking lift roller onto lift arm.