Installation Instructions

9
Note: On multiple passes (i.e., double and triple
cutting), the groomer will continue to penetrate deeper
on each successive pass. Multiple passes are not
recommended.
5. After testing the performance of the groomer on a test
green and satisfactory results are obtained, grooming on
the playing greens can begin. It is important to realize,
however, that each green may respond differently to
grooming. In addition, growing conditions are
constantly changing. Inspect the groomed greens
frequently and make adjustments to the grooming
procedure as often as necessary.
Using the Grass Baskets
The grooming reel will increase the amount of grass and
thatch picked up. This means the grass baskets will have to
be emptied more often.
To install the baskets:
1. Adjust the grooming reel to the maximum height.
2. Rotate the adjusting rods (Fig. 17) so that the top of
each rod is 1/8 in. above the tops of the grooming reel
blade. Tighten the adjusting rod nuts.
3. Readjust the groomer height/depth.
4. Install the baskets.
1
Figure 17
1. Adjusting rod
Rollers
If the grooming reels are set to a negative depth relative to
the rollers, the groomer will penetrate deeper than the
cutting unit. Because of this, the groomer will cut into the
base of the grass blade which is stickier. Grass will tend to
build up on the rear roller faster than without the groomer.
A rear roller scraper is strongly advised when grooming
reels are used.
A Wiehle roller is recommended on the front when using a
grooming reel. A Wiehle roller can also be used on the rear
to avoid grass build up if the height of cut is at or below
3/16 in. If the height of cut is set over 3/16 in., then a full
roller with scrapers is advised.