Installation Instructions

2
Description UseQty.
Right-hand link bracket
Left-hand link bracket
Carriage screw
Capscrew
Flat washer
Locknut
2
2
4
4
4
4
Mount to the Greensmaster 3250 carrier frames
if additional travel is required
Parts catalog 1
Installation Instructions 1 Rear before operating the machine.
Registration card 1 Fill out and return to Toro.
Caution
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do any
maintenance. Set the wire aside so that it does not accidentally contact the spark plug.
1. Disconnect and remove the cutting units from the
traction unit and position them on a level work surface.
2. Remove the front roller and roller brackets from the
cutting unit (Fig. 1). Retain the mounting hardware.
Note: If mounting the Groomer Kit on a cutting unit with a
serial number prior to one of those listed below, a new
shoulder bolt, eccentric bolt, and nuts must be purchased
before the roller can be re-installed with the kit.
Model No. 04480 Serial No. 60656
Model No. 04481 Serial No. 60648
Model No. 04482 Serial No. 60697
Model No. 04483 Serial No. 60985
Order the following parts from your local authorized Toro
Distributor:
Shoulder bolt (1) Part No. 95-1618
Eccentric bolt (1) Part No. 95-1617
Locknuts (2) Part No. 33024-00
3. Remove the front roller from the roller brackets
(Fig. 1). Retain the mounting set screws.
Note: The following instructions are for installing the kit
on a cutting unit with the reel motor on the right side.
Unless specified, reverse the procedure for cutting units
with the motor on the left side.
1
2
3
4
Figure 1
1. Counterweight
2. Front roller
3. Reel bearing housing
4. Grease fitting
4. Remove the cutting unit counterweight (Fig. 1) and
mounting capscrews.
5. Remove the 2 screws securing the reel bearing housing
(Fig. 1) to the counterweight end of the cutting unit. If
the screw heads are thick, replace them with tapered
thin head screws, included in this kit.
6. Install the screws from the outside as shown in Figure 2.
Secure them with the tapered nuts previously removed.
Note: Only replace the thick head screws on the
counterweight end of the cutting unit.
7. Install the drive coupler and snap ring into the reel shaft
(Fig. 2).