Installation Instructions

2
Description UseQty.
Right-hand link bracket
Left-hand link bracket
Carriage screw
Capscrew
Flat washer
Locknut
2
2
4
4
4
4
Mount to carrier frames if additional travel is
required.
Adapter fitting kit 1
Use when mounting Groomer Kit to a Model
No. 04470, 04471, 04472 or 04473 cutting unit
with a serial number of 220000001 & Up
Parts catalog 1
Installation Instructions 1 Read before operating the machine.
Registration card 1 Fill out and return to Toro.
Caution
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do
any maintenance. Set the wire aside so that it does not accidentally contact the spark plug.
1. Disconnect and remove the cutting units from the
traction unit and position them on a level work
surface.
2. Remove the front roller and roller brackets from the
cutting unit (Fig. 1). Retain the mounting hardware.
Note: If you are mounting the Groomer Kit on a cutting
unit with a serial number prior to one of those listed
below, a new shoulder bolt, eccentric bolt, and nuts must
be purchased before the roller can be installed with the
kit.
Model No. 04480 Serial No. 60656
Model No. 04481 Serial No. 60648
Model No. 04482 Serial No. 60697
Model No. 04483 Serial No. 60985
Order the following parts from your local authorized Toro
Distributor:
Shoulder bolt (1) Part No. 95-1618
Eccentric bolt (1) Part No. 95-1617
Locknuts (2) Part No. 33024-00
1
2
3
4
Figure 1
1. Counterweight
2. Front roller
3. Reel bearing housing
4. Grease fitting
3. Remove the front roller from the roller brackets
(Fig. 1). Retain the mounting set screws.
Note: The following instructions are for installing the kit
on a cutting unit with the reel motor on the right side.
Unless specified, reverse the procedure for cutting units
with the motor on the left side.
4. Remove the cutting unit counterweight (Fig. 1) and
mounting capscrews.