Installation Instructions

FormNo.3402-199RevA

CEGuardKit

forGreensmaster

3420TriFlex

TractionUnit

ModelNo.04443

InstallationInstructions

YoumustinstallthiskitonyourGreensmaster3420TriFlextractionunittomeetCEcompliance.

Installation

1.Parkthemachineonalevelsurface,lowerthecutting

units,shutofftheengine,settheparkingbrake,and

removetheignitionkey.

2.Attachtheupperradiatorguardtothetopofthe

radiatorusing2bolts(Figure1).

3.Slide2oftheclipsontotheradiatorbracketasshown

inFigure1.

4.Slidetheremainingclipontotheradiatorshroudas

showninFigure1.

5.Attachtherearguardusingthe3remainingbolts

(Figure1).

Figure1

1.Bolts5.Radiatorguard

2.Upperradiatorguard6.Bolts

3.Radiatorbracket7.Radiatorshroud

4.Clip

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3402-199*A

PAGE 1
Form No. 3402-199 Rev A CE Guard Kit for Greensmaster® 3420 TriFlex® Traction Unit Model No. 04443 Installation Instructions You must install this kit on your Greensmaster 3420 TriFlex traction unit to meet CE compliance. Installation 1. Park the machine on a level surface, lower the cutting units, shut off the engine, set the parking brake, and remove the ignition key. 3. Slide 2 of the clips onto the radiator bracket as shown in Figure 1. 4.
PAGE 2
6. Insert the side tabs of the inner guard into the engine bell housing (Figure 2). 7. Attach the outer guard to the inner guard using 2 flange-head nuts (Figure 2). Figure 2 1. Inner guard 3. Flange-head nut 2.