Installation Instructions

8
14. Position the edge of the alignment tool onto the flat
surfaces of the drive assembly and the LH height of
cut assembly, as shown in figure 25. If the surfaces do
not align, the LH height of cut assembly can be
adjusted in or out by adding or substituting .406 ID x
.812 OD x .030 thk. washers. The surfaces should be
aligned to within .030 in.
1
Figure 25
1. Alignment tool
15. Remove the cover mounting bolts, washers, flange
nuts, idler pulley and the guard plate w/bolt from the
existing brush plate (Fig. 26). and install them on the
new brush plate (Fig. 27). Leave the guard plate bolt
(Fig. 27) loose for adjustment later.
2
4
1
3
Figure 26
1. Existing brush plate
2. Cover mounting bolts,
washers and flange nuts
3. Guard plate
4. Idler pulley
2
4
1
3
Figure 27
1. New brush plate
2. Cover mounting bolts,
washers and flange nuts
3. Guard plate
4. Idler pulley
16. Remove the (2) tap bolts, spacers, nuts, idler assembly
and spring from the groomer plate (Fig. 28). and install
them on the groomer plate to be used with the roller
brush (Fig. 29).
1
4
3
2
5
6
Figure 28
1. Tap bolt
2. Spacer
3. Nut
4. Idler assembly
5. Spring
6. Groomer plate (Groomer
only)