Operator's Manual
!
+)
Loosely secure a capscrew, (2) washers, a jam nut
and a locknut to each end of roller scraper as shown in
figure 6. Rear scraper installation is shown in figure 6,
reverse scraper so edge is on top when installing on
front roller.
+)52'
#13%2'7
"#3*'2
'#2 20--'2 3%2#1'2
#. /54
0%,/54
Thread each capscrew into roller brackets until
desired clearance between scraper and roller is
attained. Make sure scraper is parallel to roller. Tighten
locknuts securing scraper to capscrews and jam nuts
securing scraper to roller.
+)
Thread jamnuts, on scraper rods, in or out to attain
.060" clearance between scraper and roller.
+)52'
0--'2 3%2#1'2
Assure scraper rod is parallel to roller and level
surface.
Adjust scraper to desired position to meet turf
conditions.
Scraper may not need to be used in dry
conditions.
! +)
"*'/ -07'2+/) 6'24+%544+/) 2''-3
%#2' .534 $' 4#,'/ 40 12'6'/4 &#.#)' 40 4*' 2''-
$-#&'3 &5' 40 %0/4#%4 7+4* # %0/%2'4' (-002 02 #
1#6'& 352(#%'
Verticutting reels, can be installed at any of the three
mounting locations on the traction unit. Figure 8 shows
the orientation of the hydraulic drive motor for each of
the locations. For any of the locations requiring the
motor to be mounted on the right end of the cutting
unit, install a counter weight on the left end of the
cutting unit. For the locations requiring the motor to be
mounted on the left end, install a counter weight on the
right end of the cutting unit.
+)52'
0402 "'+)*4"'+)*4 0402
"'+)*4 0402
Counter weights are shipped installed to right
end of the verticutting reels. The capscrews on left end
are to be used for securing the hydraulic motor.
Verticutting reels are mounted to traction unit the
same way cutting units are. Refer to Traction Unit
Operator's Manual for mounting instructions.
Before operating the verticutting reels on a fairway,
evaluate the performance of the reel at the desired
setting. Operate in a clear, unused area to determine if
the desired results will be achieved. Adjust as desired.
Operate the traction unit at full throttle and
between 3-5 MPH.
Maximum setting on the verticutting blades is 1/4"
deep penetration.
Power requirements to operate the verticutting
reels will vary with turf and soil conditions. Travel speed
may need to be reduced in some conditions.