Operator's Manual
3
ADJUSTING VERTICUTTING REEL
ADJUST BLADE DEPTH (Fig. 3)
NOTE: * ' $" ! %&&! % #
#!&$&"!
1. & ($&'&&! $ "! ( %'$
2. ' $% '!$ & $"!& ! $$
$"$% " & ($&'&&! $ %'$ $
"($% & ' !& " $"$
Figure 3
1
2
1. Roller bracket
2. Angle bracket
3. Adjusting pin
3
3. &+ ""%! $ !'& %'$! $"$
$& &" ! $&
4. "( $#! "&&$% ! $$ '%&! #!%
%'$! $"$ %'##"$&% &" %#&%
5. %! $& &$ ! ##$"#$& " !
$"$ %'##"$& ! %#& &" ( %$
#&
6. ! #$"#$ " ! $"$ %'##"$& )& #$"#$ "
! %#& #% ! %'$ )& $$ '%&!
#!% ! $#! "&&$%
7. #& #$"'$ "! $"!& $"$ '%! $&
&" &$ ! ##$"#$& " ! $"$ %'##"$&
! %#& &" ( %$ #&
8. &! !'&% %'$! $"$ $& &" !
$&
Note: As the verticutting blades wear, the diameter
of the reel will decrease and the depth setting will
change. Check height setting periodically to insure
desired setting is achieved.
Figure 4
FRONT REAR
Roller Support
Hole
(Top or Bottom)
Bottom Hole
Bottom Hole
Top Hole
Top Hole
Top Hole
Side Plate
Hole
(1 of 3)
1=top
2
2
1
1
1
Blade Depth
-1/4"
-1/8"
0
+1/8"
+1/4"
Roller Support
Hole
(Top or Bottom)
Top Hole
Bottom Hole
Bottom Hole
Top Hole
Bottom Hole
Side Plate
Hole
(1 of 6)
1=top
2
4
4
3
5
Blade Depth
-1/4"
-1/8"
0
+1/8"
+1/4"
ADJUST REAR GRASS SHIELD (Fig. 5)
NOTE: When operating in turf conditions where
much debris is encountered, or unusually heavy
thatch, open the rear discharge shield to help allow
the debris to discharge from the reel.
1. ""%! & #%$) "! & & % " &
($&'&&! $ "& "! & #("& " & $$ $%%
%
2. "&& & $$ $%% % &" & %$ %&&!
! &&! & #%$)
Figure 5
1. Rear grass shield
2. Shield screw
1
2