Form No. 3368-226 Rev A Beacon Kit Zero-Turn-Radius Riding Mowers Model No. 02842 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 © 2011—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Description Bracket Rubber gasket ROPS clamp Washer Washer (5/16 inch) Male bullet connector Female bullet M6 fastener Twin core cable Cable tie Piggyback crimp terminal Male blade connector M4 fasteners 30 amp fuse Qty.
3. Crimp a male bullet connector to the black twin cable and a female bullet to the red twin cable 1 Assembling and Mounting the Beacon G015945 1 Parts needed for this procedure: 1 Bracket 1 Rubber gasket 1 ROPS clamp 2 Washer 2 Washer (5/16 inch) 2 Male bullet connector 2 Female bullet 1 M6 fastener 1 Twin core cable 8 Cable tie 2 Figure 2 1. Female bullet 2. Male bullet connector 4.
1 1 2 2 3 ! 4 G015946 G015942 5 Figure 5 1. Ignition switch 6 2. Screw 7 Figure 4 1. 2. 3. 4. Bolt Washer Clamp (50 mm or 60 mm) ROPS 2. Cut the cable to a suitable length and strip the insulation. 5. Bracket 6. Washer (5/16 inch) 7. Nut 3. Remove the existing connector on the ignition switch, then connect the red wire to the position shown using a piggyback crimp terminal. Reconnect the removed connector to the piggyback. 6.
For Models GM 7200/7210 DANGER Electrical shock can cause serious injury or even death. Disconnect the battery before performing any electrical work. 1. Remove the control panel side cover. 2. Cut the cable to a suitable length and strip the insulation. 3. Connect the red wire to the pink wire using a male blade connector. G015943 Figure 8 Mounted beacon kit 2 G015941 1 Figure 7 1. Male blade connector 2. Ground ring terminal 4.
Maintenance Maintenance Tips • Verify that the bulb is functional and that the reflector rotates properly. • Clean the beacon regularly with a non petroleum-based cleaner. • Always verify that the beacon is secured firmly to the mower before use. • Ensure that the drain slots are kept clear of debris. • If the mower is going to be stored outdoors, verify that the lens is secured properly to prevent water from entering the beacon.
Notes: 6
Notes: 7
The Toro Total Coverage Guarantee A Limited Warranty Conditions and Products Covered The Toro® Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first. This warranty is applicable to all products with the exception of Aerators (refer to separate warranty statements for these products).
