Installation Instructions

FormNo.3368-273RevA

FixedHead200mm(8in)FittingUnit

T4240Mower

ModelNo.02826

InstallationInstructions

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Roller2

Splitpin

Leftbracket

Rightbracket1

Nut4

Washer4

Bolt4

Installthettingunit.

InstallingtheFittingUnit

Note:Arrowsindicateforwarddirection.

1.Removetheexistingsplitpins,washers,andfront

rollersandretainthem(Figure1).

g019205

Figure1

1.Washer(existingpart)3.Splitpin

2.Roller

2.Installtheoriginalwasher,thenewsplitpin,andthe

newfrontrollers.

3.Securetheleft-wingheadstopbrackettotheinside

endoftheleft-wingcutterheadusing2bolts,nuts,and,

washers(Figure1).

CAUTION

Contactwiththereelbladewhenttingthe

boltscancauseinjury.

Usecautionwhenttingtheboltstothe

cutterhead

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUK.

AllRightsReserved

*3368-273*A

PAGE 1
Form No. 3368-273 Rev A Fixed Head 200mm (8in) Fitting Unit T4240 Mower Model No. 02826 Installation Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. Roller Split pin Left bracket Right bracket Nut Washer Bolt 2 2 1 1 4 4 4 Installing the Fitting Unit Note: Arrows indicate forward direction. 1. Remove the existing split pins, washers, and front rollers and retain them (Figure 1). Install the fitting unit. 3.
PAGE 2
1 2 3 4 g019206 Figure 2 Left cutterhead shown 1. Nut 2. Washer 3. Bracket 4. Bolt 4. Secure the right-wing head stop bracket to the inside end of the right-wing cutterhead using 2 bolts, nuts, and washers (Figure 3). 2 1 g019207 Figure 3 1. Left-wing cutterhead 2.