Product Manual

OPERATING INSTRUCTIONS

Adjustable - Top Column Assembly

Guide Rods

Base Frame

Power Unit

Handle

Tilting Support Beam

and

Adjustable - Slide Bar Assemblies

Chain Attachments

3” Caster Wheels

Plastic knob with threaded stem

TO RAISE PARTS

1. Place part in on slide bar assemblies.

2. Use chain hook if needed to secure part.

3. Use upper guide rods to keep part aligned for doors, door skins, plates, ect… if needed.

4. Close the release valve by turning the handle clockwise as far as it will go.

5. Position the jack so that the saddle is centered and will contact the load lifting point rmly.

6. Before raising the vehicle double check and verify the saddle is centered and also has full contact with the lifting

point.

7. Continue to pump the jack handle to lift the vehicle to the desired height.

TO LOWER PARTS

1. Raise the load.

2. Grasp the handle rmly with both hands. Securely hold on the jack handle so your hands do not slip and ensure the

release valve does not rapidly lower.

3. Carefully open the Release Valve by slowly turning the handle counterclockwise. (Do not allow bystanders around

the jack or under the load when lowering the device.)

WARNING

jack. The jack handle may turn rapidly. Opening the

release valve to fast can cause the jack to lower rapidly.

Failure to head these warnings could cause serious

injury or death.

Use extreme caution when lowering the

Oil Fill

* Product use example.