Torbal Printers Instruction Manual RXP-4 Thermal Printer Fulcrum Inc. 23 CarolAve.,Suite Street. 100 Delawanna 120 Clifton, NJ 07014 (973) 473-6900 (973) 777-8302 http://www.fulcruminc.
Specifications Model: RXP-4 Printing: - Speed - 0.8 lines per second - Characters - 40 characters per line Transmission parameters: - Speed - 9600 baud - Format - 8 bits without parity Paper: - Type - Thermal Paper - Size - 4.3” W DIP Switch Settings Dimensions: - Size - 6.5 W x 5.5D x 2.0H inches (165 x 140 x 50 mm) - Weight - 1.0 pounds (0.45 Kg) The printer's settings are preconfigured for all TORBAL scales and should always remain as shown below.
Inserting and replacing the paper roll Parts Description 1. Before you begin inserting the new paper roll into the printer, use scissors to cut off the corners of the paper approximately 1 inch from each side as shown. This will allow you to easily insert the new roll. On/Off switch RS232C Port AC Adaptor socket Paper feed button Power indicator 2. Once the paper has been prepared, remove the printer cover by lifting it upwards.
2. After removing the printer and all of its components from the packaging, connect the printer to the scale by plugging in the RS232C connector to the printer and the RS232 connector to the scale. R232C (plugs into the printer) Typical Setup RS232 (plugs into the scale) 3. After connecting the printer to the scale, plug in the AC adaptor to the AC adaptor socket located at the rear of the printer. 4. The printer is now ready to use.
