User's Manual

USING THE REMOTE CONTROL LEARNING

FUNCTIONALITY [if available]

The TV Power, VOL+, VOL-, Numeric keypads (0 through 9), CH+, CH-, and

Mute buttons on the remote control for Media Center PC and “learn” IR

commands from other remote controls. This feature lets you use the Media

Center Remote Control sends commands to your TV or another device, such

as an audio receiver or home stereo set.

※Important:

 By default, the VOL+, VOL-, Numeric keypads (0 through 9), CH+,

CH-, and Mute buttons on the remote control for Media Center PC

control the system volume and channel on your computer, and the TV

button has no command assigned to it until it “learns” one.

 Do not perform this procedure in bright natural or artificial light.

To program buttons on the remote control by using the learning feature

1. Place the remote control for Media Center PC head to head

(approximately 5cm apart) with the remote control from which it is

learning.

2. On the remote control for Media Center PC, press and hold the DVD

MENU button and then press OK button, and right after you release

both buttons you will see the Green LED turns on for 5 seconds.

The remote is now in learning setup mode.

3. On the remote control for Media Center PC, press and release the TV

Power, VOL+, VOL-, Numeric keypads (0 through 9), CH+, CH-, or

Mute button, depending on which command you want it to learn.

The remote control for Media Center PC Green LED blinks once to

confirm the selection.

In the learning setup mode, Red LED blinks quickly four times when two

conditions occurring: (Try again, repeat steps 1 to 3)

 If you press other buttons than TV Power, VOL+, VOL-,

Numeric keypads (0 through 9), CH+, CH-, and Mute buttons

 If you do not press any button in 5 seconds.

4. On the remote control that is teaching the command, press and hold the

button that you want the corresponding button on the remote control for

Media Center PC to learn

Before you release to hold this button, the remote control for Media

Center PC Green LED blinks twice to confirm the selection.

If the remote did not learn the command, the Red LED blinks quickly

four times. To try again, repeat steps 1 through 4.

5. Repeat steps 1 through 4 for the other buttons that can learn

commands.