User's Manual

ManualsBrandsTopSeed Technology ManualsElectronicsRF Flex Pointer - FSK

Flex Pointer-TS/AS User Manual

How to use the remote:

1. Plug the receiver unit into any USB port.

1. Your operation system will start to setup the receiver unit. There is no software to load. (Win98/Me may show some dialog boxes during setup process.

Press “Next” on all dialog boxes and then “finish”. During setup process, the O/S may ask you to put Win98 CD into the CD-ROM.)

2. After the setup process finish, the remote will work.

Notice:

1-1.Remote power on : Press and hold the “ “ key and press “ ” buttons more than 3 seconds the remote will be Power ON .

Pic.1 Pic.2

1-2. Use a paper clip to press the receiver unit red button (Stand by to learn the new ID)---Pic.2

1-3. Press any button except “ “ button to operate. (Let receiver unit learn the new ID).

2.If you remove the battery or the remote does not work, repeat the steps 1-1 to 1-3.

Summary of content (2 pages)

PAGE 1
Flex Pointer-TS/AS User Manual How to use the remote: 1. Plug the receiver unit into any USB port. 1. Your operation system will start to setup the receiver unit. There is no software to load. (Win98/Me may show some dialog boxes during setup process. Press “Next” on all dialog boxes and then “finish”. During setup process, the O/S may ask you to put Win98 CD into the CD-ROM.) 2. After the setup process finish, the remote will work. Notice: 1-1.Remote power on : Press and hold the “ Pic.
PAGE 2
Symbo Key Black definition Display a black screen or return to the slide show from a black screen Slide Perform the next animation or advance to the Forward next slide Slide Back Perform the previous animation or return to the previous F5/ESC F5: Running your slide show in full screen mode ESC:End a Slide show Mode Key NOTE:1. If the remote is not working or interference with another: ID Change : Press Both “ “ and “ ” buttons simultaneously more than 3 seconds will change the currend ID .