MX MX.6FX 6-CHANNEL MIXING CONSOLE WITH DIGITAL EFFECTS MIC INPUT MIC INPUT STEREO AUX RETURNS AUX SENDS CTRL RM OUT L L PHONES R BAL UNBAL R BAL UNBAL MX.
MX MX 15
MX MX 1. INTRODUCTION ............................................................................................................4 2. FEATURES .....................................................................................................................4 3. USEFUL DATA ..............................................................................................................4 4. CONTROL ELEMENTS.................................................................................................6 5.
MX MX Thank you for purchasing the MX.6FX 6-channel mixing console with 24-bit digital multi-effect. MX.6FX mixing console is a remarkable compact mixing desk that does not find many equals in the market today. With 2 microphone and 2 stereo Line-level inputs for small live performances, small studio recording and general PA applications, MX.6FX also includes a 24-Bit digital multieffect with 16 Factory Presets and separate level for digital reverb.
MX 9 MX HOOKUP DIAGRAM SMALL GIG Mono input channels Frequency response Distortion (THD & N) 0.005% at +4 dBu, 1 kHz Gain range 0 dB to 60 dB (MIC) SNR (Signal to Noise Ratio) Line input MIC INPUT Equalization 10 Hz to 55 kHz, +/ 3 dB Distortion (THD & N) 0.005% at +4 dBu, 1 kHz DSP Section 10 Hz to 55 kHz, + / 3 dB Distortion (THD & N) 0.005% at +4 dBu, 1 kHz Microphone Input 1.4 k Ohms 10k Ohms or Greater Main Mix Section 120 Ohms Hi shelving +/ 15 dB @12 kHz Mid bell +/ 15 dB @ 2.
MX MX FRONT PANEL MIC INPUT 1- MIC INPUT MX.6FX is equipped with 2 low-noise microphone preamplifiers with optional phantom power, 60 dB of Gain and 115 dB of S/N ratio. You can connect almost any type of microphone. Dynamic microphones do not need phantom power. Use phantom power only with condenser microphones but make sure that the phantom power button is disengaged before connecting the microphone.
MX MX Either the 1/4" TRS phone jack or XLR connector can be wired in balanced and unbalanced modes, which will be determined by the actual application status, please wire your system as the following wiring examples: For 1/4" Phone jack + - + Tip + Tip Ring Ring Sleeve Sleeve This stereo output is controlled by the Main Mix Level on Master section and will send the audio signal to an amplifier or to a pair of active speakers. The output level can be varied from - to +15 dB.
MX MX 15- PAN/BAL This is the PANORAMA control, or balance control. You can adjust the stereo image of the signal via this control. Keep this control in center position and your signal will be positioned in middle of stage. Turn this control fully counter clockwise and the signal will be present only on the left speaker and vice-versa. Of course a large number of intermediate positions is available. 16- PEAK LED This red LED will let you know about the status of the signals processed into MX.6FX.
