MX.12FX 0.032KG NH00149 1:1 A3 A4 PHFAA102-20110300021 A5 MX.12FX TOPP PRO_V1.0 -RS- NF03555 TOPP PRO SEIKAKU TECHNICAL GROUP LIMITED 8 NPD-TO-201012003 4PCS MAR.15.
MX.12FX USER' S MANUAL MX.12FX 75Hz 75Hz 75Hz +4 10 75Hz DSP NF03555-1.
MX .12FX SAFETY RELATED SYMBOLS M X .
MX .12FX 9 M X .12 F X TABLE OF CONTENTS TECHNICAL SPECIFICATION Internal Digital Effect PEAK Indicator VU Meters Impedance Presets 100 1. INTRODUCTION...................................................................................1 Controls 100-Position PRESET Selector and Mute Switch 2. FEATURES...........................................................................................1 Display Two 7-egment display and Mute/Peak LED Indicator 3. USEFUL DATA...............................
MX .12FX INTRODUCTION Thank you for purchasing the MX.12FX mixing console. There is 3-band EQ on mono channels. These M X .12 F X TECHNICAL SPECIFICATION Frequency Response Mic Input to any Output (Gain @ 0 dB, Rated output level) 20 Hz to 50 kHz(0, -1dB) 20 Hz to 130 kHz(0, -3dB) Please read this manual carefully so you can take advantages of all the features of the MX12FX. Distortion(THD&N) Mic Input to MAIN Output(Gain @ 0 dB, Rated output level @ 20 Hz-20 kHz bandwidth) 0.
M X .12FX 8 M X .12 F X PRESET LIST HOOKUP DIAGRAM No. Preset Description Parameter Small Club Gig Active Speakers Microphones 1 and 2 00~09 Vocal Simulate a small space with slight 10~19 Small Room Simulate a bright studio room Decay time: 0.7~2.1s Pre-delay: 20~45ms Rev.delay time: 0.8~0.9s Pre-delay: 10~45ms 20~29 Large Hall Simulate a large acoustic space Decay time: 3.6~5.
M X .12FX M X .12 F X BLOCK DIAGRAM CONTROL ELEMENTS 1- Mono MIC Input The MX series is equipped with one or more low-noise microphone preamplifiers with optional phantom power providing up to 50dB of amplification. You can connect almostany type of microphone. Dynamic microphones do not need phantom power. Use phantom power only with condenser microphones but make sure that phantom power switch is disengaged before connecting the microphone.
M X .12FX M X .12 F X WIRE CONNECTIONS CONTROL ELEMENTS Either the 1/4" TRS phone jack or XLR connector can be wired in balanced and unbalanced modes, 10- PAN/BAL which will be determined by the actual application status, please wire your system as the following Abbreviation of PANORAMA control for mono channels, for stereo channels, always says, BALANCE control. You can adjust the stereo image of the signal via this control.
M X .12FX M X .12 F X CONTROL ELEMENTS CONTROL ELEMENTS 20- POWER LED 31- PEAK/MUTE LED This LED lights up when the power switch is turned on. +48V 21- PHANTOM 48V LED This LED will light up when the phantom power is switched on. NOTE: Turn down all output levels before operating this switch to avoid the possibility of "pop" in your speakers. Do not use phantom power with tube or ribbon microphones, as this may cause damage.
