User Manual

5
1. Turn the POLE/SAT-BM/SAT-TP back control switch to “LOCK” position.
2. Place the EVENT 2K on a flat surface and rotate the POLE/SAT-BM/SAT-TP from low to high into the bottom
threaded bracket until it is tight.
3. After the installation is completed, if you choose to turn the control switch to the “UNLOCK” position, you
can rotate the column to any angle. If you need to fix the angle, turn the control switch to the “LOCK”
position.
4. If you need to disassemble, turn the control switch to the “LOCK” position, and then rotate the column in
the opposite direction.
Connect Manner
UNLOCKLOCK
EVENT 2K
6