User Manual

7
DSP Control
The EQ menu is a 4-band EQ (equalizer) that the user can fine tune in addition to FUNCTION and LOCATION.
The options available for this selection are: HI, MD, LM, and LO.
User Programs user save settings
There are 16 presets available for user storage, stored as the currently set EQ value, which can be named
according to user requirements. It can be written in 7-digit English or letters and symbols; it can be set
according to the load/Save/Delete related EQ.
System menu
The System menu is used to configure the system. You can also configure the accessibility of this menu and
modify the settings, reset to factory defaults.
The FIRMWARE / HARDWARE menu is used to display, preset version, firmware version.
User Programs
01:EMPTY
02:EMPTY
03:EMPTY
User Programs
05:EMPTY
06:EMPTY
07:EMPTY
User Programs
11:EMPTY
12:EMPTY
13:EMPTY
User Programs
14:EMPTY
15:EMPTY
16:EMPTY
User Programs
15:EMPTY
16:EMPTY
EXIT
User Programs
01:EMPTY
02:EMPTY
03:EMPTY
Save
Delete
Load
User Programs
01:EMPTY
02:EMPTY
03:EMPTY
Delete
Exit
Save
Back
HI
MD
LM
LO
12.1K
2.52K
500.0
101.5
Default: 0 decibels
Range: -18 decibels – +18 decibels
ALLBYPASS will be deleted, invalidating all set EQs.
FLAT is to restore all the adjusted EQ to factory settings.
NOTE!
The indoor equalizer (EQ) range shown is the factory default range for individual speakers. When the
woofer is selected, any EQ below the crossover point is bypassed.
To use EQ above the crossover point, do the following:
> Rotate the button to reach the desired frequency.
System
FIRMWARE V1.0
HARDWARE V1.0
Name: EVENT 2K
Default Settings Exit
11