User Manual

BACK PANEL DESCRIPTION
4
6
(1) AC POWER SOCKET WITH MAIN FUSE.
(2) ON-OFF MAIN POWER SWITCH.
(3) IP CONTROL
(4) Preset Selector: V4 / V8 / User (Custom Sound)
V4: Allow use this subwoofer with the 4 speaker satellite. Defaults Factory preset
V8: Allow use this subwoofer with the 8 speaker satellite. Defaults Factory preset
User: Adjusts the Equalization according to the convenience of the user, depending on the
acoustics of the place and the implementation of the system. This setting can be performed
by a PC via LAN port, using a router for internet. This “preset” comes from factory set with
the parameters of the V4, after making the necessary changes you can be save into the
system.
(5) SWITCH FOR FRONT LED ON OR OFF
(6) THRU OUTPUT ON XLR CONNECTOR
This is a male XLR-type connector that produces exactly the same signal that is connected to
the main input jack or a mix of input1 and input2.
(7) POWER. GREEN LED, INDICATE ON STATUS.
(8) SIGNAL / LIMIT, RED LED, INDICATE ON STATUS.
(9) Input 2 Volume Control
(10) LINE / MIC INPUT1 ON COMBO CONNECTOR.
(11) LINE / MIC SWITCH(CHANNEL INPUT1 ONLY)
(12) XLR AND 1/4” COMBO INPUT1
INPUT1 may accept a MIC or line-level signal via XLR or line-level signal via TRS 1/4” cable.
Be aware of the position of the MIC / line switch (11).
(13) XLR AND 1/4” COMBO INPUT2
INPUT2 may accept Hi-Z sources (such as guitars) via the TRS 1/4” input, or line-level signal
via XLR.
NEVER connect the output of an amplifier directly to the input of the loudspeaker. This could
damage the input circuitry of the active loudspeaker.
(14) RCA INPUTS(INPUT2 ONLY).
(15) CONVECTION FAN
(16) INPUT1 / MIX SWITCH (THRU OUTPUT)
This switch allows you to choose whether only the input1 signal is sent out to the next
loudspeaker(switch out-input1) or mix of the input1 and input2 signals are sent out to the
next loudspeaker(switch in-Mix).
(17) SPK connector to satellite: Use pins + 1 positive / -1 negative
SOHO S12
8