User Manual

5
BACK PANEL DESCRIPTION
4
(1) AC POWER SOCKET WITH MAIN FUSE.
(2) ON-OFF MAIN POWER SWITCH.
(3) SPK connector to satellite: Use pins + 1 positive / -1 negative
(4) CONVECTION FAN
(5) IP CONTROL
(6) THRU OUTPUT ON XLR CONNECTOR
This is a male XLR-type connector that produces exactly the same signal that is connected to
the main input jack or a mix of input1 and input2.
(7) Preset Selector: V4 / User (Custom Sound)
V4: Allow use this subwoofer with the 4 speaker satellite. Defaults Factory preset
User: Adjusts the Equalization according to the convenience of the user, depending on the
acoustics of the place and the implementation of the system. This setting can be performed
by a PC via LAN port, using a router for internet. This “preset” comes from factory set with the
parameters of the V4, after making the necessary changes you can be save into the system.
(8) SWITCH FOR FRONT LED ON OR OFF
(9) POWER. GREEN LED, INDICATE ON STATUS.
(10) SIGNAL / LIMIT, RED LED, INDICATE ON STATUS.
(11) INPUT2 ON COMBO CONNECTOR.
(12) LINE / MIC SWITCH(CHANNEL INPUT1 ONLY)
(13) LINE / MIC INPUT1 ON COMBO CONNECTOR.
(14) XLR AND 1/4” COMBO INPUT2
INPUT2 may accept Hi-Z sources (such as guitars) via the TRS 1/4” input, or line-level signal
via XLR.
NEVER connect the output of an amplifier directly to the input of the loudspeaker. This could
damage the input circuitry of the active loudspeaker.
(15) XLR AND 1/4” COMBO INPUT1
INPUT1 may accept a MIC or line-level signal via XLR or line-level signal via TRS 1/4” cable.
Be aware of the position of the MIC / line switch (12).
(16) RCA INPUTS (INPUT2 ONLY).
(17) INPUT1 / MIX SWITCH (THRU OUTPUT)
This switch allows you to choose whether only the input1 signal is sent out to the next
loudspeaker(switch out-input1) or mix of the input1 and input2 signals are sent out to the
next loudspeaker(switch in-Mix).
SOHO S10
8
16