Quick Start Guide

All rights reserved. No part of this work may be reproduced or copied in any form or by any means (graphic, electronic, or mechanical, including photocopying,
recording, recording taping, or information and retrieval systems) without the written permission of the copyright owner
5
Removing the cradle cable (12pin molex connector) if you don’t want to use it.
1. you can find the rubber plug in our blackbox (see below picture).
2. open the cradle casing by screw driver
3. remove the 12pin molex cable from connector
4. put the rubber plug in the hole and close the cradle casing
Option for ignition control the power supply
If ignition is OFF, the power supply will cut. Customer uses their application to control the device to
power off or sleep mode.
If ignition is ON, there is power supply and able to charge the device. so, when the engine is ON, the
device will power on automatically.
If you want to try this feature, pls open the cradle. There are switch inside the cradle PCB. (only
production batch >1642)