Quick Start Guide

All rights reserved. No part of this work may be reproduced or copied in any form or by any means (graphic, electronic, or mechanical, including photocopying,
recording, recording taping, or information and retrieval systems) without the written permission of the copyright owner
4
2. There are Rs232 interface and OTG from cradle.
Highlights: OTG port from device (10pin usb connector) and cradle are sharing same pins. Only 1 OTG
interface can be used.
Pin 1 – Ignition (Green), it can be wake up the device. see the software section for more details.
Pin 2 – NOT connected
Pin 3 – RTS (Orange)
Pin 4 – car battery input (12-28V) (Red)
Pin 5 – CTS (yellow)
Pin 6 – TXD (purple)
Pin 7 – RXD (White)
Pin 8 – GND (grey)
Pin 9 – GND (black)
Pin 10 – NOT connected
Pin 11 – NOT connected
Pin 12 – 5V input (Pink)
Highlights: for RS232, it is master mode definition.
if you are using OTG with external device, you can only charge the device by 12V input.
This cable can be customized when you placed
order
For sample, it will be 12 pins connector, pls see
below or pins assignment
Usb connector for
OTG or charging