Quick Start Guide
All rights reserved. No part of this work may be reproduced or copied in any form or by any means (graphic, electronic, or mechanical, including photocopying,
recording, recording taping, or information and retrieval systems) without the written permission of the copyright owner
13
Video input cradle
We made a new video input cradle
1. For rear view camera input, we have complete demo kit (part number: CRD741R)
Highlights for P2 connector:
1. It is same as before. We just add video trigger (pin 12), this video trigger can support only 9-32V
2. The ignition status cannot read by device anymore. It is used only to control the power supply from
the device. If ignition is ON, the device can be charged. If ignition is OFF, the device cannot be charged.
Highlights for P3 connector:
It used to connect camera module directly. It has power supply for camera.
For software, we made apk (topiconDemo_20161115). If the video trigger is HIGH, the device will pop
up the video with external video input from P3