User's Manual

5.3.1 It is VERY IMPORTANT to fix the 4 SIM card cover screws to prevent water from

leaking inside and cause damage to device.

5.3.2 TOPFLYtech offers the electric screwdriver (TA38) as an optional accessory to help

customer standardize the screw fixing strength.

5.3.3 Please use strength level 8 if using TOPFLYtech electric screwdriver (TA38)

5.3.4 For third party electric screwdriver, please use torque 3.5kgf.cm.

5.4 Installation

5.4.1 Away from emission source such as all kinds of sensors, burglar alarm and other

communication devices.

6. Tracker Operation

6.1 Physical power on or off

6.1.1 Turn the power switch to on or off position.

6.1.2 Physical power off is recommended when the tracker is stored in the warehouse.

6.2 The battery

6.2.1 Place the tracker solar panel side on the desk

6.2.2 Recommend connecting the device to a 5V 1A (cellphone) adaptor through

magnet USB cable for 30 hours charging to make sure the battery is fully charged.

6.2.3 Customer also can connect the tracker to other USB connectors. But lower current

output will cause longer charging time.

6.2.4 When the battery voltage value drops to 3.3V, usually a battery charging is

needed to avoid unexpected shutdown due to low power. If the battery runs out

completely, please keep the tracker charging for 24 hours first. Only when the

battery is charged to 3.5V, the device will power on again.

6.3 Get Current Position

6.3.1 SMS Query (only when the device in working mode and registered on the network)

Device default PIN is 0000. Send a location inquiry SMS command (google,0000#)

to the tracker. The location information will be sent back through SMS (the tracker

SIM card must support receiving and sending SMS first).