Operation Manual

24 Service Search
4. Set the Motor Control option to Goto. Then the antenna
will turn toward your selected satellite by the position
data that the digital receiver has.
5. If the receiving quality is not good, tune the antenna
finely with the Movement option. If you set it to 2(E),
the antenna will move to the east by two degrees. At this
time you had better check the receiving quality of every
transponder and choose the best one at the Transponder
(or Frequency) option. It will be helpful to your fine tun-
ing.
6. Finally set the Motor Control option to Store to save the
tuned position when the receiving quality is best.
There are more motor control options for installers, but this
guide does not describe them. If you are an installer, refer them
to the manual about the STAB rotor.
3.1.3 Configuring USALS settings
USALS (Universal Satellite Automatic Location System), also
known as DiSEqC 1.3, calculates the positions of all available
satellites from your location. Compared to DiSEqC 1.2, it is
no longer required to manually search and store every satellite
position. Just pointing to a known satellite position is enough.
This position will act as a central point. The USALS will then
calculate positions of visible satellites.
To use the USALS protocol, se-
lect the Installation > USALS
Setting menu. You should see
a screen like the left figure. At
first you have to set the Motor-
ized DiSEqC 1.3 option to En-
able.