Operation Manual

2 Setup
2.4 Connecting up your digital receiver 15
To use the Component video output
Y
Pb
Pr
You need to obtain a Component video ca-
ble (RCA cable) to use the Component video
output. Plug one ends of the cable into the Y
(green), Pb (blue) and Pr (red) sockets on the
digital receiver, and plug the other ends into
the matching sockets on your television.
NOTE
When connecting with the Component video cable, remem-
ber to also plug in the additional white and red audio cables
from the digital receiver to the back of your television.
When an HDMI cable is connected, component output be-
comes disabled. If you want to output component video, do
not have the HDMI cable and component cable connected at
the same time, and make sure to disconnect the HDMI cable.
To use the Composite video output
You need to obtain a Composite video cable
(RCA cable) to use the Composite video out-
put. Plug one end of the cable into the VIDEO
(yellow) socket on the digital receiver, and
plug the other end into the matching socket
on your television.
NOTE
You cannot view high definition video by means of the Com-
posite video output.