Operation Manual

12 Setup

2.4 Connecting up your digital receiver

There are several ways to set up the digital receiver. Set up the

digital receiver suitably to your television and other devices.

If you have any problem with your setup or need help, contact

your dealer.

WARNING

Connect any components before plugging the power cord

into the wall outlet. Always turn oﬀ the product, TV and

other components before you connect or disconnect any ca-

bles.

NOTE

If you encounter any problems setting up your product,

please contact your local retailer.

2.4.1 Connecting to the antenna

Whatever sort of connection you have be-

tween the digital receiver and the television,

you need to connect the digital receiver to the

antenna so that it can receive digital televi-

sion broadcasts. Connect the antenna cable

to the LNB 1 IN connector on the back panel

of the digital receiver.

Also, you must ensure that there is a connec-

tion to both the LNB 1 IN and LNB 2 IN con-

nectors on your digital receiver, so that both

tuners work properly.

Normally you do that by using a loop cable to link from the

LNB 1 OUT connector to the LNB 2 IN connector.

If you have two antennas without DiSEqC switch, then you

have to connect the cable from the other antenna directly to

the LNB 2 IN connector rather than using the loop cable.