User's Manual

   WT11EC USER’S MANUAL

Over View

This device is a class 1,Bluetooth® 2.0+EDR (Enhanced Data Rates)module.

Physical Specifications

Table A-1 Physical Specification

 Dimensions W: 43mm D: 20mm H: 4.3mm

Weight 4g

Input / output UART interface/Power/antenna

Input voltage 3.3V± 5%

Operating temperature -40 to +85℃

Storage temperature -40 to +85℃

Wireless specifications

Table A-2 Wireless Specifications

Standard Bluetooth Version 2.0 Class 1

Frequency modulation technique T GFSK(1Mbps), π/4 DQPSK(2Mbps), 8DPSK(3Mbps)

Hopping 1600hops,1MHz channel space

Frequency Range 2404-2478MHz

Output power 12dBm

Installation Guide

1. Module connected to UART Port on the mother Board in your Equipment. (see below)

NAME SPEC MODEL

I/F Connecter UART Port DF16-40DP-0.5v

RF Connector

Antenna coaxial connector

U.FL-R-SMT

*We are preparing driver software.

Confirm the homepage of Microsoft to the method of installing the driver software.

You must make sure that 20cm minimum separation is maintained between users and the antenna.

Mother Board

UART Port

Bottom View

Top View

Connect to UARTPort

Antenna

PAGE 1
WT11EC USER’S MANUAL Over View This device is a class 1,Bluetooth® 2.0+EDR (Enhanced Data Rates)module. Physical Specifications Table A-1 Physical Specification Dimensions Weight Input / output Input voltage Operating temperature Storage temperature W: 43mm D: 20mm H: 4.3mm 4g UART interface/Power/antenna 3.3V± 5% -40 to +85℃ -40 to +85℃ Wireless specifications Table A-2 Wireless Specifications Standard Frequency modulation technique T Hopping Frequency Range Output power Bluetooth Version 2.
PAGE 2
Warning Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Regulatory Information Compliance statement to FCC/IC This module complies with part 15 of the FCC rules and IC RSS-210. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 3
For Class B device; NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.