Product Manual

Properties Window
MAGNET Tools ver 1.0
82
• Antenna Height
- the GPS antenna's height for the occupation, in
current units. To edit the value, click on the highlighted column
and enter a new value.
• Antenna Height Method
- the method used to measure the
antenna height. You can change the type of the method (slant or
vertical) with the help of the drop-down list.
- Vertical – measured from the ground point to the antenna
reference point (ARP) located on the bottom of the receiver.
- Slant – measured from the ground point to the antenna slant
height measure mark (SHMM).
• Antenna Centering Error
- the centering error of Antenna
Reference Point (ARP) position over the mark, in the horizontal
plane. This error will be taken into account when estimating
adjustment results. To edit the value, click on the highlighted
column and enter a new value.
• Antenna Height Error
- the measurement error of the antenna
height over the mark. This error will be taken into account when
estimating adjustment results. To edit the value, click on the
highlighted column and enter a new value.
Offset Tab of the Properties Window
for a GPS Occupation
You can open this tab if the Properties command from the pop-up
menu for the highlighted line in the GPS Occupations tab
was
selected.
• The tab displays non-zero values when the imported MAGNET
Field job contains Azimuth & Offsets
data and this offset was
performed from the measured point (See the picture of the
Azimuth & Offsets). The tab contains the following offset
information for the given occupation:
• Azimuth
- the horizontal angle to the offset point, in current
linear units.