Product Manual

Inverse Tab
MAGNET Tools ver 1.0
67
• Hz. Dist
– the horizontal offset (in the current linear units) from
the center line for the offset. You can edit the value.
• V.Dist
– the vertical offset from the horizontal plane for the
offset. You can edit the value. When you enter this parameter, the
Grade
will be automatically calculated.
• Grade
– the ratio of horizontal offset (Hz. Dist) and vertical offset
(V.Dist
) multiplied by 100%. When you enter this parameter, the
V.Dist
will be automatically calculated.
• Hz. Offset from CL (m)
– the horizontal offset from the center
line for the start point of the given offset. It is calculated using the
corresponding values of the previous offset(s), and it is not
editable.
• V. offset from CL (m)
– the vertical offset from the horizontal
plane for the start point of the offset. It is calculated using the
corresponding values of the previous offset(s), and it is not
editable.
Right-click on a highlighted line to display a pop-up menu. This
menu contains a set of commands that can be divided into three
groups:
common commands for all tabs of the Tabular View
specific commands for the left panel of the X-Section
Templates tab
specific commands for the right panel of the X-Section
Templates tab
Inverse Tab
The Inverse tab displays a table that lists the results of the inverse
calculations. The table appears only then you click either the Inverse
button in the Toolbar, or COGO -> Inverse in the Main Menu.
The results are displayed in the tab after clicking Calculate Button
in
the Inverse window
. This table stores the previous results of the
inverse calculations.