Product Manual

Tabular View
MAGNET Tools ver 1.0
66
X-Section Templates Tab
The X-Section Templates tab is shown only if the job contains a road
with X-Sections data. The tab has two panels. The left panel displays
a list of available X-Section templates and values of the cut and fill
slopes in percent. The right panel displays the offset(s) of the selected
template in table and graphic mode.
The left panel can have the following informational columns:
• Icon
- the symbol of the X-Section template.
• Name
- the name of the X-Section template. You can edit the
name.
• Cut Slope (1:n)
- represents the horizontal increment of the slope
for a unit of vertical increment. The cut slope is used when the
road surface is below the terrain. By default, cut slope equals 0
(units in percent). You can edit the parameter.
• Fill Slope (1:n)
- represents the horizontal increment of the slope
for a unit of vertical increment. The fill slope is used when the
road surface is above the terrain. By default, fill slope equals 0
(units in percent). You can edit the parameter.
The right panel of the X-Section Templates tab has the following
default columns for segments used in the selected template:
• Icon
– the symbol of the offset. For the offsets the icon is
using.
• Name
- the name of the offset. You can edit the name and leave
the field empty.
• Order
– the order of the offset in the template. You can set any
number from the list of offset numbers.