Product Manual

Tabular View
MAGNET Tools ver 1.0
56
• ZAngle Residual
- displays the residual of the zenith angle after
adjustments for both enabled and disabled TS observations.
• HDist Residual
- displays the residual of the horizontal distance
after adjustments for both enabled and disabled TS observations.
• VDist Residual
- displays the residual of the vertical distance
after adjustments for both enabled and disabled TS observations.
• Cross Residual
– displays the residual of the horizontal angle
represented in linear measure after adjustments for both enabled
and disabled TS observations.
Right-click on a highlighted line to display a pop-up menu. This
menu contains a set of commands that can be divided into three
groups:
common commands for all tabs of the Tabular View
specific commands for the left panel of the TS Obs tab
specific commands for the right panel of the TS Obs tab
DL Obs Tab
The DL Obs tab is shown only if the job contains DL raw data. The
DL Obs tab displays a table containing two panels. The left panel
displays all DL Run (or DL occupation), and the right panel displays
all DL observations. The left panel can have the following
informational columns:
• Icon
- a symbol associated with the DL occupation. For details,
see a list of symbols in the left panel of the DL Obs tab
.
• #
- the number of the DL run (DL occupation) contained in the
current job. You can set any number from the list.
• From
- the start leveling point of the job. You cannot select
another point as the start point.
• To
-the finish leveling point of the job. You cannot select another
point as the finish point.