Product Manual

Tabular View
MAGNET Tools ver 1.0
54
• Reflector Height
- the vertical distance from the Reflector Center
Mark to the ground, in current linear units. To edit the value,
click on the highlighted field and enter a new value.
• Azimuth
- the azimuth value that defines the orientation of TS
measurements by backsight from the station in the horizontal
plane. The field displays non-zero values only for BKB type. If
you set a point as backsight in the field, the azimuth value is
calculated using the coordinates of the station point and the
backsight point. In this case, you cannot edit the azimuth value. If
you set an azimuth as backsight, in the field, then you directly
enter the azimuth value. In this case, you can edit the azimuth
value in the software.
NOTE: The software allows you to edit
the azimuth value for the BKB observation type only if the Point
To field is empty.
• Horizontal Circle
- for the SS, FS, Horizontal Resection/Vertical
Resection/Resection types of Total Station observation. This is
the measured horizontal angle from the previous to the next
observation. For BKB type, it is the horizontal circle reading
when pointing to the backsight point. You cannot edit this
parameter.
• Zenith angle
- the vertical angle to the reflector measured from
zenith. You cannot edit this parameter.
• Slope Distance
- the slope distance between the TS station (Point
From) and the TS observation (Point To). You cannot edit this
parameter.
• Vertical Angle
- the vertical angle to the reflector measured from
the horizontal plane. You cannot edit this parameter.
• Horizontal Distance
- the distance between the TS station (Point
From) and the TS observation (Point To) in the horizontal plane.
You cannot edit this parameter.
• Vertical Distance
- the distance between the TS station (Point
From) and the TS observation (Point To) in the vertical plane.
You cannot edit this parameter.
• Note
- any additional TS observation's note. To edit the note,
click on the highlighted field and enter comments.