Product Manual

Tabular View
MAGNET Tools ver 1.0
50
• Rover Antenna Height Method
- the method used to measure the
rover antenna height. You can change the type of the method
(slant or vertical) with the help of the drop-down list.
Vertical – measured from the ground point to the antenna
reference point (ARP) located on the bottom of the receiver.
Slant – measured from the ground point to the antenna slant
height measure mark (SHMM).
• AutoReject
- In this field you can select the status of the given
GPS observation for Adjustment:
- Allowed - the GPS observation will be used in Adjustment.
- Not Allowed - the GPS observation will not be used in
Adjustment.
• Adjustment Status
- the status of the given GPS observation after
Adjustment:
- Not Adjusted - the GPS observation is not adjusted.
- Adjusted - the GPS observation is adjusted.
- AutoRejected - the GPS observation is not adjusted,
because the vector had the status Not Allowed before the
adjustment procedure.
- Disable - the GPS observation is not adjusted, because the
vector was disabled before the adjustment procedure.
• Engine/Mode
- the Engine Type and Engine Mode that were
selected in the GPS+ PostProcess (the Engine tab) Process sub-
menu option for the last post-processing of the GPS observation.
• Elevation Mask
- an elevation cut-off angle (in degrees) for
satellites used in data processing. This parameter was entered in
the GPS+ PostProcess (the General tab) Process sub-menu option
for the last post-processing of the GPS observation.
• Satellite System
- the navigation system (either GPS and
GLONASS or only GPS satellites) that is used for post
processing the GPS observation.This selection was entered in the
GPS+ PostProcess (the General tab) Process sub-menu option for
the last post processing of the GPS observation.