Product Manual

Points Tab
MAGNET Tools ver 1.0
39
coordinate type depends on the selected coordinate system in the
Status Bar or Job Configuration window:
- If
WGS84 Lat, Lon, Ell.H is selected, the coordinates
columns have the corresponding names WGS84 Latitude
/
WGS84 Longitude
/WGS84 Ell.Height. You see latitudes,
longitudes and ellipsoidal heights in the WGS-84 coordinate
system in these columns.
- If
WGS84 X,Y,Z is selected, the coordinates columns
have the corresponding names X
/Y/Z. You see Cartesian
coordinates (XYZ) in WGS-84 coordinate system in the these
columns.
- If
Datum Lat, Lon, Ell.H is selected, the coordinates
columns have the corresponding names Latitude
/Longitude/
Ell.Height
. You see latitude, longitude and ellipsoidal heights
in the current datum in these columns.
- If
Datum Lat, Lon, Elevation is selected, the
coordinates columns have the corresponding names Latitude
/
Longitude
/ Elevation. You see latitude, longitude and
orthometric heights (elevation) in the current datum in the
these columns.
- If
Ground | None or Ground | Localization is selected,
the coordinates columns have the corresponding names
Ground Northing
/Ground Easting/Elevation. You see
northings, eastings, orthometric heights (elevation)
coordinates in the ground coordinates system in these
columns.
When a projection is defined for the job, the Status Bar
contains the Grid coordinate system in the list of coordinate
systems. If
Grid is selected, the coordinates columns have
the corresponding names Grid Northing
/Grid Easting/
Elevation
. You see the point's northings, eastings,
orthometric heights (elevation) coordinates in the grid
coordinates in these columns.
• Code
– the primary code used for the point. If a point has multiple
codes, all codes of the point will be displayed here using a