Product Manual

Quality Control Item of the Job Configuration Window
MAGNET Tools ver 1.0
33
Note: To create your own set of DL precisions, select Custom in the
Precision Order / Class field (1044) and enter any values. After
clicking Ok in the DL Observation Precisions tab, the application will
save these values for further use.
Loop Closure Precisions Tab of
Quality Control Item
In the tab you can set a threshold value of precision for the Loop
Closures test. You can run the Loop Closures test for post-processed
GPS observations that form a loop, by clicking the Loop Closures
icon. The threshold value (horizontal and vertical) for the test is
computed by a formula:
If the residual (in the corresponding plane) after performing the Loop
Closures test for the closed figure is worse than the computed
tolerance, the residual will be highlighted in red in the Loop Closures
Report.
The tab contains the following fields in the current linear units:
• Horizontal Tolerance absolute
- the current value of the absolute
tolerance in the horizontal plane. You can edit the value.
• Vertical Tolerance absolute
- the current value of the absolute
tolerance in the vertical plane. You can edit the value.
• Horizontal Tolerance relative
- the current value of the relative
tolerance in the horizontal plane. You can edit the value.
• Vertical Tolerance relative
- the current value of the relative
tolerance in the vertical plane. You can edit the value.