Product Manual

Job Configuration Window
MAGNET Tools ver 1.0
26
• TS Obs Precisions tab
• DL Obs Precisions tab
• Loop Closure Precisions tab
• Automatic Tests tab
Point Precisions tab of Quality
Control Item
In the tab you can set the threshold value of horizontal and vertical
precisions for the coordinates of points of the processed GPS
observations in static and kinematic modes, and localization points.
The tabs contains the following editable fields with the values in the
current linear units:
• Static Horizontal Precision
- the current threshold value of the
horizontal precision for the processed, adjusted or RTK
coordinates of the static points. If the horizontal precision for a
point is worse than the value in the settings, the point will be
highlighted in red in the Points tab, Observation View and
Reports.
-When you check the "PP Static Precisions
" test in the
Automatic Test tab
, the application will highlight only worse
point(s) after post - processing the network.
- When you check the "Point Standard Deviations
" test in the
Automatic Test tab
and check "By Quality Control" in the
Rejection Criterion
, the application will highlight only worse
point(s) after adjusting the post-processed network and worse
Topo point(s) of the RTK survey.
• Static Vertical Precision
- the current threshold value of the
vertical precision for the processed or adjusted or RTK
coordinates of the static points. If the vertical precision for a point
is worse than the value in the settings, the point will be