Product Manual

Quality Control Item of the Job Configuration Window

MAGNET Tools ver 1.0

- adjust the vertical plane by displaying the elevation

precision for each network point, if the "Compass Rule"

adjustment type is selected.

- calculate elevation for each network point, if the

"Unadjusted closure" adjustment type is selected.

Note: The application uses only the least-squares method for the

adjustment of GPS observations.

Quality Control Item of the Job

Configuration Window

In the Quality Control item you can set:

- the threshold value of precision for points, GPS/TS/DL

observations

- the horizontal and vertical tolerances for loop closures

- choose to perform quality control tests from the predefined list

There are two ways to change the values in the tabs:

- manually: open the corresponding tab and enter the desired

value.

- automatically: load the corresponding job configuration which

contains the desired values for all tabs.

The Quality Control item contains the following tabs:

• Point Precisions tab

• GPS Obs Precisions tab