Product Manual

Job Configuration Window
MAGNET Tools ver 1.0
22
observation precision set in the Quality Control Item of the
Job Configuration window.
- A failed test is where the difference is more than the
horizontal/vertical observation precision set in the Quality
Control Item of the Job Configuration window. The network
adjustment process will be interrupted and the Adjustment
Diagnostic window will display.
Note: The repeated observations are two or more observations
with common start/end names. The observations N1-N2 and N2-
N1 are assumed to be repeated.
• Analyse Identical Points
- if this parameter is checked (default
setting), the application will perform the test of the identical
points:
- A successful test is where the coordinate difference for a
pair of identical points is more than the horizontal/vertical
point precision set in the Quality Control Item of the Job
Configuration window.
- A failed test is where the difference is less than the values
set in the Quality Control Item of the Job Configuration
window. The network adjustment process will be interrupted
and the Adjustment Diagnostic window will display.
• Control Tie Analysis
- if this parameter is checked (default
setting), the application will perform the test of the coordinates of
the control points. The Control Tie Analysis test compares the
control coordinates with the corresponding coordinates computed
using GPS/ TS/DL observations.
- A successful test is where the difference is less than
horizontal/vertical point precision set in the Quality Control
Item of the Job Configuration window.
- A failed test is where the difference is more than the value
of the horizontal/vertical point precision set in the Quality
Control Item of the Job Configuration window. The network
adjustment process will be interrupted and the Control Tie
Analysis window will display.