Product Manual

Coordinate Systems Item of the Job Configuration
MAGNET Tools ver 1.0
13
“i” is the number of elements in the alignment.
“Length” is a distance of “i - element” from the start point.
“Interval for Station” is equal to 100 current linear units.
(This parameter is not editable).
The second part is a remainder from this ratio. For example: the
length of the line is 1288.50 meters; the number of the end station
for this line is 12+88.5.
• When you select the “Chainage” type, the number of the station is
a value equal to the distance from the start point. For example:
the length of the line is 1288.50 meters; the number of the end
station for this line is 1288.5.
Angles Tab of the Display Item
The tab sets the format of angular values.
•In the Angles
field you can select the format for such angular
units as Azimuth, Horizontal Circle, Vertical Angle, Zenith
Angle, Azimuth Residual, Horizontal Angle Residual, Vertical
Angle Residual, Zenith Angle Residual.
•In the Lat,Lon
field you can select the format for such angular
units as Latitude and Longitude.
Coordinate Systems Item of
the Job Configuration Window
The Coordinate Systems item contains the two following tabs in the
right panel: