Product Manual

Display Item of the Job Configuration Window
MAGNET Tools ver 1.0
11
The Display item contains the four following tabs in the right panel:
•In theIP
recisions tab you can set the viewing number of digits
after the decimal for the various measurements.
•In the Time tab
you can set the GPS time zone offset and
automatically adjust the clock for daylight savings changes.
•In the R
oads tab you can set the type of number to use for the
center line position.
•In the Angles tab
you can set the format of angular values.
Precision Tab of the Display Item
The Precisions tab sets the viewing number of digits to display after
the decimal for various measurements:
• Distances
- in this field you can set the number of digits displayed
after the decimal for distances. The default is 3.
• Coordinates (N,E;X,Y,Z)
- in this field you can set the number of
digits displayed after the decimal for plane and Cartesian
coordinates (northing and easting, or X, Y, Z). The default is 3.
• Heights
- in this field you can set the number of digits displayed
after the decimal for all height measurements. The default is 3.
• Angles (seconds)
- in this field you can set the number of digits
displayed after the decimal for seconds of angular observations
represented in degrees, minutes, and seconds. The default is 4.
• Angles (dec. degrees)
- in this field you can set the number of
digits displayed after the decimal for angular observation format
in decimal degrees (dd.ddd). The default is 7.
• Lat,Lon (seconds
) - in this field you can set the number of digits
displayed after the decimal for the seconds in latitudes and
longitudes. The default is 5.