Product Manual

How To
MAGNET Tools ver 1.0
168
of site and a plane defined by three points. You create three
auxiliary points, then performs distance and angle measurements
to these points, and angle measurements to the offset point.
After importing the MAGNET Field job with Plane and Corner
data into the current MAGNET Tools job, the right panel of the
TS Obs tab displays all measurements performed for calculating
the offset point. In this case MAGNET Tools applies the same
Point to name for Plane and Corner type measurements:
You cannot edit the offset values in the MAGNET Tools job.
Point
From
Point To Horizontal Cir-
cle
Slope Dis-
tance(m)
Zenith Angle Type
A Offset_Point 80 00 00.000 200.40 29 00 00.000 Plane
A Offset_Point 82 00 00.000 253.00 28 00 00.000 Plane
A Offset_Point 101 00 00.00 256.00 27 00 00.000 Plane
A Offset_Point 105 00 00.00 30 00 00.000 Corner