Product Manual

How To
MAGNET Tools ver 1.0
166
vertical plane passing through the offset point. After importing
the MAGNET Field job with Lines and Corner data into the
current MAGNET Tools job, the right panel of the TS Obs tab
displays all measurements performed for calculating the offset
point. In this case MAGNET Tools applies the same Point to
name for Line and Corner type measurements:
You cannot edit the offset values in the MAGNET Tools job.
• Line and Offset: Determination of the horizontal and vertical
(3D) coordinates of an inaccessible point, using an auxiliary line
and additional distance offsets measurements, for example made
by the tape. You create a line (by two points), then performs
Point
From
Point To Horizontal Cir-
cle
Slope Dis-
tance
Zenith Angle Type
A Offset_Point 78 00 00.000 110.00 91 00 00.000 Line
A Offset_Point 59 00 00.000 78.00 92 00 00.000 Line
A Offset_Point 37 00 00.000 93 00 00.000 Corner