Product Manual

Editing and Viewing MAGNET Field Offsets in the Job
MAGNET Tools ver 1.0
165
After importing the MAGNET Field job with Two Line
Intersection data into the current MAGNET Tools job, the right
panel of the TS Obs tab displays all measurements performed for
calculating the offset point. In this case MAGNET Tools applies
the same Point to name for Line type measurements:
You cannot edit the offset values in the MAGNET Tools job.
•
Lines and Corner: Determination of the horizontal and vertical
(3D) coordinates of an inaccessible point, as intersection an
auxiliary line and a plane. You create a line (by two points) and a
Point
From
Point To Horizontal Cir-
cle
Slope Dis-
tance
Zenith Angle Type
A Offset_Point 45 00 00.000 100.00 91 00 00.000 Line
A Offset_Point 62 00 00.000 140.00 92 00 00.000 Line
A Offset_Point 130 00 00.00 110.00 91 00 00.000 Line
A Offset_Point 102 00 00.00 129.00 93 00 00.000 Line